Double-click the wireless network card management icon to open the network card client management software.After finishing the installation, in the lower right corner of the taskbar, [REALTEKK Client Management Software appears, indicating the installation succeed.(Note : If the installation file is a compressed package, you need to extract it to install it. Open the driver folder and double click the installation file “Setup.exe”.Put the CD driver into the computer drive.(Most of the desktop computer’s front USB interface is underpowered or unavailable), extended to the desktop Use, the effect is better! Driver Installation Note: When using the desktop, it is recommended to use the USB extension cable base to connect the rear interface of the computer chassis. Connect the USB port of the computer through the USB extension cable base.Please insert the usb adapter directly into the computer’s USB port.I have very basic coding abilities, so even just telling me not to waste my time would be much appreciated! Thank you in advance for your time and consideration. I am hopefully using the correct terminology. Or should I attempt to port the RTL8822BU driver to support ARM64? Would it make the most sense to take the necessary pieces for RTL8822BU and build them into the RTL8812AU driver that already supports ARM64 for RPi? There are a lot of files and I have plenty of curiosity and not enough experience.Ĭan someone with wireless driver experience please try and point me in the right direction? c files used within the drivers may need to be changed in some way. I have tried to combine both drivers in a number of ways, but I imagine the underlying. There is also a driver for RTL8812AU that supports ARM64 for RPi ( ). This driver supports arm, but not arm64 which is what I require. There is a driver that supports RTL8812BU which is RTL8822BU ( ) Machine: Linux kali 4.19.29-Re4son-v8+ #6 SMP PREEMPT Wed Mar 27 00:15: aarch64 GNU/Linuxįrom my research.

usb 1-1.1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-1.1.2: New USB device found, idVendor=0bda, idProduct=b812, bcdDevice= 2.10 usb 1-1.1.2: new high-speed USB device number 4 using dwc_otg However, much to my surprise after looking up the id Product once I plugged it in, it is actually RTL8812BU ( ). I assumed (you know what they say) that it would be RTL8812AU for which there is an ARM64 driver available to be installed on Kali. The driver described within the specification was RTL8812. I recently purchased a new wireless adapter for use with Kali Linux running on a Raspberry Pi 3B+.

Rtl8812bu mac driver